Rocket Tuned by Mike's

Shimano Soccorro 8000F Carbon Drag Kit

This is the HT100 drag upgrade, which we feel is the best all around washer for ANY reel. It offers a smooth startup, good holding power, and because it is a carbon drag washer, will not heat up and...

Abu Bearing Drive Shaft

Custom drive shaft with ball bearing in the base portion. This bearing supports the bulk of the load imposed on the drive shaft as the handle is turned under pressure. Outer portion of the drive...

Hardy Longstone Spool Repair

This old Hardy Longstone came to us in a collection of reels to be refurbished. This was by far the worst one in the collection as most of the spool had corroded and broken away. All that was left of...

Daiwa 250RL Carbon Drag Kit

This is the HT100 drag upgrade, which we feel is the best all around washer for ANY reel. It offers a smooth startup, good holding power, and because it is a carbon drag washer, will not heat up and...

Rapala Moocher Click Spring

FEB 11/21 - 1 Remaining in stock then no longer available, sorry. Click spring for Rapala North Coast NC1 & Classic CM-1 Mooching reels. These springs are a close match and about the same...

Daiwa Lightened and Polished Spool

This particular spool was from a Daiwa TD-A 153 HST baitcast reel. The spool wieghed in at 25.85 grams before the lightening procedure and now weighs in at 25.33 grams. Over a half ounce of...

1/8' x 3/8' x 5/32' Stainless Bearing

1/8" ID x 3/8" OD x 5/32" W Stainless Steel bearing, sheilded one side to facilitate easier cleaning Can substitute for Penn 26-13H (need to use your original bearing cup)

Okuma SI40a Carbon Drag Upgrade

Carbon drag kit that will fit your Okuma Stinson SI40a spinning reel.Kit contains 3 carbon drag washers6-360

Shimano Pawl Tool

Ever have a Shimano baitcast reel that has a stubborn, stuck pawl inside the line guide? Well, instead of beating your reel on the table to unstick that pawl, get one of these tools. Not only will it...

DAIWA AD47LC CARBON DRAG KIT

Fits: ACCUDEPTH AD17LC, 27LC, 27LCW, AD47LC/57LC, AD47LCi/57LCi Set of 3 washers Replaces Daiwa part #'s W60-7301 (X2), W60-7101 This is the HT100 drag upgrade, which we feel is the best all around...

Daiwa SKA1655 Carbon Drag Kit

This is the HT100 drag upgrade for the Daiwa SKA 1655 rear drag spinning reel. It offers a smooth startup, good holding power, and because it is a carbon drag washer, will not heat up and fade like...

8X14X10mm Clutch Bearing

HF081410 One Way Clutch Bearing, made for us to EU spec standards. High Quality at an affordable price!Dimensions: C: 10mm, Fw: 8mm, D: 14mmNote: these bearings do not fit the Ambassadeur side plates.