STH

STH SLT Drag Disc w/cork, Outer

Drag dis for STH Salt (SLT) series fly reels.  Disk is about 1.25" across and has a 3/8" hole. The FOUR posts engage into the body, at the drag knob.

STH MEDALLION

The STH Medallion is an essential accessory designed specifically for STH fly reels, seamlessly combining functionality with style. Crafted with precision, this button measures approximately 14.5mm...

STH CASSETTE REEL FOOT

STH, CORTLAND CASSETTE REEL FOOT WITH OFF SET SCREW HOLES. The base of the foot sides have a slight flare

STH Teflon Drag Washer 7/8"

STH Salt Series (SLT) teflon washer. Measures about 7/8" across with a 3/8" hole and just over 1/8" thick.

STH Teflon Drag Washer 3/8" - NLA

STH Salt Series (SLT) teflon drag washer. Measures about 3/4" across with a 3/8" hole. ***NO LONGER AVAILABLE***

STH Teflon Drag Washer

STH Salt Series (SLT) teflon drag washer. Measures about 1.25" across with a 3/8" hole.

STH SLT Drag Disc w/cork, Inner

Drag dis for STH Salt (SLT) series fly reels.  Disk is about 1.25" across and has a 3/8" hole. The two posts engage into the clutch disc.

STH Stop Pin

This is the standard stop pin used in most STH fly reels.TO install, you'll need to remove the old pin assembly. To do so, there is *usually* a hole (sometimes covered up with paint) under the latch...

STH REVERSIBLE DISC - NLA

***NO LONGER AVAILABLE***STH REVERSIBLE DISC TO FIT MOST STH FLY REELS. DISC CAN BE FLIPPED FOR EITHER LEFT OR RIGHT HAND RETRIEVE

STH LOWER DRAG PAD, OLD STYLE

oLDER style STH lower drag pad. This is only for STH reels without the screw in the drag knob. If your reel has the new system that DOES have a screw in the center of the drag knob, you will need to...

STH LOWER DRAG PAD, NEW STYLE

New style STH lower drag pad. This is only for STH reels with the screw in the drag knob. If your reel has the old system that DOESN'T have a screw in the center of the drag knob, you will need to...

STH UPPER DRAG PAD

STH upper drag pad to fit most STH fly reels. Yours may have a plastic and cork drag pad, this one is metal with a Teflon drag surface. Screw holes remain unchanged.